ELMED SPG10, Инструкция по эксплуатации, Страница: 17 / 33

Mitterweg 25 – Via di Mezzo ai Piani 25
I -39100 Bozen - Bolzano Tel.:0471 977236 - Fax:976525
e-mail: info@elmed.it http://www.elmed.it
17
 Speed
This is where the recommended speed that should be adhered to when driving with the
sprayer is displayed in km/h. (Small deviations in speed are taken into consideration as
the vehicle is moving and compensated for automatically).
Note: When the speed limiter function is active, then the value entered here (minus 0.2
km/h) is used as the threshold value. (For more information see Setup → chapter 6.8
“Minimum speed”)

Nozzle-type
The type of nozzle used (ATR or ISO) can be selected in the corresponding selection
area (Fig. 15). The nozzle colour can be chosen in the neighbouring area. The
recommended nozzle colour indicated beneath is determined using the spray
programme settings.
3.2.2.2
SBR South Tyrol Option
The window with the “SBR South Tyro option”
programme settings only appears, if the check-box
for the “Calculation by SBR South Tyrol option” is
activated in the Service menu (

chapter 7.1).
Otherwise follow the instructions in the previous
chapter (

3.2.2.1).
The following parameters can be set:

Number of nozzles
The number of nozzles in each ring is shown
individually in the top part of the screen (in
clockwise order, starting with the bottom left
ring).
To adapt the number of nozzles press this top
area and a window will open (Fig. 18), where
the position of the nozzle rings with the
number of nozzles are shown in graphic form
(bottom left to bottom right). Press one of the
nozzle rings (=selection fields) to define a new
number of nozzles.

In the case of multi-row sprayers, just the
number of nozzles per sector needs to be
indicated.

Area
The area to be worked is taken from the data for the assigned field. It can be adjusted
individually here.

Concentration
The spray concentration can be set here (1 to 30).
Fig. 17: Spray programmes - page 2
Fig. 18: Selecting the number of nozzles