Elkron FAP54, Руководство по установке

Страница: 27 / 40

FAP54 Installation 27
CIRCUIT 1: OPEN
CIRCUIT 2: LOOP
CIRCUIT 3: ------
CIRCUIT 4: FAULTY
∨
CIRCUIT 5: EXCLUDED
∧
CIRCUIT 6: OPEN
CIRCUIT 7: ------
CIRCUIT 8: ------
∨
5 ADDRESSING
FAP54 control panels can manage up to 128 devices for each detection line.
The devices can be addressed in manual mode or in a completely automatic mode.
In case of manual addressing, the following constrains are applied:
•
The address is univocal and no duplicates are admitted, even on a different line section.
•
Valid addresses are in the range 1-128
•
There is no correlation between device type and address.
•
Progressive addressing is not necessary, addresses can be assigned in any sequence.
To manually address a device use the feature “CONFIGURE LOCAL DEVICE”. See the programming manual for
further details.
In case of automatic addressing it is possible to:
•
address one single line
•
address simultaneously all the lines
In both cases it is necessary to define the type of line:
•
Open
•
Loop
To enable automatic addressing follow the steps below:
•
Press the menu key
•
Select programming (option 1)
•
Press “OK” to confirm selection
•
Select “1” to select the “Circuit” menu
•
Select “1” to configure all the circuits
•
Select “2” to configure the single circuit
•
Select “3” to configure the circuit manually
5.1 CONFIGURE ALL THE CIRCUITS
The user can select the configuration of each circuit separately (loop or open).
Keys
∧
and
∨
are used to select the circuit, while keys < and > are used to select the type (open/loop). The
latter can be selected only for present and working modules (neither faulty nor excluded).
If a module is not present, a dashed line will be drawn instead of the type.