Elkay Manufacturing Company
10
Installation & Maintenance Manual (1000005506 Rev D)
4. First, using a 3/16 hex key, remove the back cover
and place it aside.
469
5. Unlock and open the lower front door panel and install
the filter element.
462
a.
Remove the cap from the new filter element.
b.
Insert the new filter into the filter head, turning it
clockwise (to the right) until it stops.
6. Prepare the water inlet line.
491a
a. Place the black insulation tubing over the 3/8" blue
water tubing.
b. Cut off a short section, approximately 3 to 4 inches,
of insulated tube.
c. Cut the remainder of the tube, if desired, to easily
reach the in-wall water supply connection.
Note:
Excess tubing can be curled up and fastened
to the back of the unit in order to be able to pull the
unit away from the wall if necessary for service
.
NOTICE
To prevent water damage,
make sure the water line is
stored in a manner that prevents it from being
pulled out of the unit or damaged.
CAUTION
Make sure the water
inlet line is stored
and secured behind the unit and does not
become a tripping hazard.
d. Connect one end of each tube to the quarter-turn
shut-off valve.
e. The end of the short tube will connect into the
water inlet line at the rear of the unit after the next
step.
f. Make sure the shut-off valve is in the OFF position
and connect the end of the long tube into a second
in-wall shutoff valve from the municipal water
supply line.
7. Fill the ice bank.
a. If not already removed, use a 3/16 hex key to
remove the back cover and place it aside.
469
