Elite Greenhouses 7'5'' VANTAGE, Инструкция по эксплуатации

Страница: 28 / 36

28
FITTING THE DOOR HANDLES
The handles are fitted to the infill panel on each door (choose between 1st or
2nd panel down). Position the handle centrally, and mark the hole position.
Drill 7mm diameter holes (2 holes per door), then fit the handles, and secure
with a nut and bolt.
FITTING THE DOOR LOCK
The door lock must be fitted after the doors are in position
(Key Point). Undo the ring bolt from the
door lock, and insert the barrel through the hole in the panel from the outside. Reattach the ring bolt
to the barrel on the inside, and tighten.
Now attach the cam lever, washer and screw to the door lock from the inside position of the door.
The lock will turn through 90 degrees both ways, so you must ensure the cam (when fitted) is point-
ing skywards (unlock position) and horizontal (locked position)
Now using a cropped head bolt, attach the domed pin to the bolt channel of the handed door post on
the left hand door (viewed from outside). Move the pin up or down in the channel so that the notch
on the cam locates comfortably when horizontal. Tighten all components.
FITTING THE RAMP
The final aluminium piece of the greenhouse is the door end ramp cill. The ramp is attached to the
door end cill by engaging the nub of the door end cill to the ‘C’ groove of the ramp. The ramp is
now rotated to horizontal. Drill a hole at each end approx. 20mm in from the end of the ramp and
into the floor. Plug and screw.
If you are fitting onto soft ground, you must ensure that a solid material is underneath the ramp to
avoid damage when you step on the ramp to enter the greenhouse. You can lay a row of bricks sunk
to ground level, a concrete flag, a piece of aluminium base pressed into the ground to ground level
or something similar. You can then screw the ramp into the support material for a secure fixing.