Elite Greenhouses 7'5'' VANTAGE, Инструкция по эксплуатации

Страница: 25 / 36

25
PARTITION
If you purchased a partition it is at this point that you construct the frame in situ. In the box you will
find packs marked
“partition corner bars”
“partition door end built in base cill”
“partition door end”
“partition door track”
“partition door panels”
“partition door posts”
You will also require a number of fittings from the box:
2 eave gusset plates
2 base plates
1 ridge plate
Glazing beading
Nuts and bolts
PROCEDURE:
1. Starting with the corner bars, identify the roof and side, left and right hands as you did earlier.
2. Each bar has a saw cut approx. 20mm into the bar from each end, but apart from that they are
identical. Insert glazing beading as before – but this time into all 3 grooves of the corner bar.
(Key
point).
3. Having established where the partition is going you will need to make the holes in the gutter,
ridge and built in base cill slots. Do this by carefully hack sawing down into the hole to form the
slot.
4. Take the left hand side bar, insert 2 bolts into each of the 2 bolt slots, and then offer it up to the
eave/gutter and cill so that the flange of the built in base cill and the eave are inserted into the saw
cut.
(Key point).
5. Slide the 2 bolts into the bolt slot facing inwards, to the holes in the built in base cill and eave/
gusset. Put a nut on and finger tip tighten. Do the same with the left hand roof corner bar having
first inserted 2 bolts into each bolt slot. (Don’t forget to ensure that the ‘R’ is at the ridge and not at
the eave) now do the same with the other side and roof corner bars.
6. Next, offer the gusset plates to the corner bar at the point where they meet. Slide the bolts in the
facing bolt slot towards the gusset plates and line up the holes in the gusset plate with the bolts in
the facing bolt slot and in the flange of the corner bar. Insert 2 bolts through the gusset plate and
flange (middle 2 holes), put a nut on – finger tip tight. Do not put the nuts on the upper and lower
bolts of the eave gusset plates at this stage.
(Key point).
7. The built in base pieces can now be attached to the facing bolt slot of the partition corner bar (in
the same way you did during the original door assembly.