Elite Greenhouses 7'5'' VANTAGE, Инструкция по эксплуатации

Страница: 13 / 36

13
12. You can now attach the 3 vertical glazing bars to the built in base cill in a similar manner to 11
above, the longer bar to the middle hole, and the shorter ones to the outer holes. Before attaching
the nuts to the shorter glazing bars place the diagonal angles onto the bottom bolt and put a nut on
finger tip tight only. Attach the other end of the angle brace to the
bottom bolt of the eave gusset
plate, put on the nut and finger tip tighten. (Key point). Do the same with the other diagonal brace.
13. Moving to the top of the greenhouse, insert 3 bolts into the
shorter two glazing bars and 2 bolts into the longer glazing bar.
14. Now you can attach the long angle horizontal brace marked
“rear end” in the box to the
top bolts of the eave gusset plates. The
angle should be facing upwards, put the nuts on and finger tip tight-
en.
15. You can now attach the 3 vertical glazing bars to the roof/corner
bars. Slide the last bolt in each bar you inserted in 13 above to the
end of each bar and insert them through the holes in the flange of
the roof corner bar, place the nuts on and finger tip tighten.
16. Slide the second bolt previously inserted in 13 above to the middle of the bar and line it up with
the hole in the diagonal brace, put the nuts on finger tip tight.
(Key point).
17. Now attach the horizontal brace to the 3 upright glazing bars utilising the final bolts you insert-
ed in 13 above. Put the nuts on finger tip tight.
(Key point).
18. Slide a bolt into the bolt slot in the built in base section, one at each end. Attach the corner
bracket/base leg so that it is pointing downwards. If you are fitting your greenhouse onto soft
ground, then do not fit the corner bracket/base leg yet. If you are on a patio, you will need to cut the
corner bracket/base leg off level with the bottom of the built in base and slide extra bolts into the
bolt channel to be attached to the anchor brackets (generally 1 every 2’). If you are on soil, the cor-
ner bracket/base leg will go into the ground at general assembly.
19. The rear end is now almost complete. Before tightening all nuts check the corners to ensure they
are tightly up against each other and that all the vertical bars are tight up against the angle of the
rear end cill and corner bars. Tighten all nuts; the rear end is now complete.