Elite Greenhouses 7'5'' VANTAGE, Инструкция по эксплуатации

Страница: 15 / 36

15
6. Slide 2 bolts into the top of the 2 long glazing bars. Attach the short horizontal brace to the 1st
pre inserted bolt of the long glazing bars and then in turn attach the other end of the horizontal brace
to the
top bolt of the gusset plate. (Key point).
7. Attach the main door track support (shaped like a letter Z) to the 2nd pre inserted bolt in the long
glazing bars.
This ‘Z’ shaped bar must be fitted with the two outside slots facing upwards (as illus-
trated) not downwards. The position to fix the main door track support is at the top of the long glaz-
ing bar at the point where it meets the roof corner bar (using the pre fabricated hole in the roof cor-
ner bar).
8. Stand the frame up and bolt the door track to the main door track support by inserting 3 bolts into
the bolt slot of the door track. Position the bolts through the 3 holes in the door track support above
the door opening. Position the top door track centrally and then tighten up.
9. Now fit the small glazing bar above the door track to the hole in the centre of the door track sup-
port, and then to the middle (of 5) hole in the ridge gusset plate.
10. Check that all joints are tight and all braces are in position, and then tighten up all nuts. The end
is now complete.
N.B. Please note carefully the correct position of the main door support. The slotted holes at either
end are facing skywards NOT downwards.
(Key point.)
You have now completed the 4 main frames of the structure which can now be joined together.
You need not do this procedure on the base but any flat surface near the greenhouse site. If your
base is prepared however, you can carry out the assembly there to save lifting it on later. But before
this we construct the vents and doors.