Elite Greenhouses 7'5'' VANTAGE, Инструкция по эксплуатации

Страница: 27 / 36

27
PARTITION DOOR TRACK
This door track is fitted in exactly the same way as the exterior door track so the instructions above
apply..
N.B. The small flat bar illustrated is fitted pointing
downwards for the partition. (Key point).
The small glazing bar above the middle of the door can now be fitted. Put the glazing beading into
the grooves and trim to suit. Insert 2 bolts into the bar and put them through the holes in the top
door track and apex gusset plate. Put nuts on and tighten up.
NOW YOU FIT THE VENT TO THE RIDGE
Before sliding the vent into the ridge, slide a piece of black tube into the vent hinge socket. Slide
the vent into position, insert a small self tapping screw into the tube approximately half way along
then tighten the screw. The tube will expand and lock into position thus preventing sideways move-
ment of the vent. N.B. There is no hole for the screw but it will easily push into the tube and screw
up
(Key point). You only require one tube per vent on the left side of the vent socket (viewed from
inside the greenhouse).
Having slid the vents from the end of the ridge to the desired position, you can now fit the ‘slam
bars’ to the 2 glazing bars. Utilise the bolts you inserted during general assembly and position the
‘slam bars’ just under the vent allowing the casement stay to effectively close. The slam bar can be
adjusted later to facilitate good opening and closing of the vent.
FITTING THE DOORS TO THE STRUCTURE
The doors slide onto the frame from the left and right hand side.
For the left hand door, put the door bottom rail into the bottom door track and slide to the right, feed
the first wheel into the upper door track and move further to the right until the black draught exclud-
er butts up to the end block glazing bars. Carefully ease the door past the block glazing bar and feed
in the second wheel. Push further to the right until the draught excluder butts up to the end block
glazing bar. The door will now run quite freely. Fit the right hand door from the right hand side in
the same way. To square up the doors with the spacing, undo the upper bolts holding the door track.
There is a little play to facilitate “fine tuning” of the door.