Elite Greenhouses 6'3" WIDE THYME, Инструкции и иллюстрации

Страница: 27 / 36

FINISHING OFF
To prevent the door from sliding past its opening, you must fix 4 angle brackets to the door end
assembly. Insert a cropped head bolt into the bolt channel at the top of the right hand glazing bar
(viewed from the inside) and fix and angle bracket as shown in the picture below.
The bracket must be fitted at the same height as the door panel so that, as the door moves left or
right, the bracket prevents the door from moving too far along the top door track.
Repeat at the bottom of the door.
Repeat for the 2nd door.
To facilitate smooth running of the door, fit 1 flat bar at each end of the top door track.
The flat bar has 2 holes of different size.
Loosely fix the larger hole to the bolt channel at the back of the top door track using a short bolt
and allow the flat bar to hand vertically down.
Move the flat bar along the top door track until the small hole in the flat bar meets the self tapping
screw groove in the roof corner bar.
Fix the small hole in the flat bar to the corner bar using a self tapping screw.