Elite Greenhouses 6'3" WIDE THYME, Инструкции и иллюстрации

Страница: 12 / 36

SHELF FITTING
The diamond shelf is intended to fit on the rear gable end of the greenhouse. Not only is it very
functional, but it adds lots of strength to the greenhouse.
The parts required for the shelf are:
2 shelf top sections
10” cantilever braces x 4
Angle supports with 45º mitre at one end x 4
Nuts/bolts
You must decide the height you want your shelf to be fitted. Fix one of the angle supports to the top
unoccupied bolt in the 1st, 2nd, 4th and 5th vertical glazing bar at the desired height (with the
square edge against the greenhouse wall, mitred edge sticking out). The angle supports must be ex-
actly the same height.
The shelf is not fitted to the corner bars when fixed to rear of greenhouse.
Attach a cantilever brace to the lower unoccupied bolt in the bolt channel of the glazing bar as
shown in the diagram above. Do not attach the other end of the cantilever yet.
The shelf top section are fitted to the angle supports utilising the bolt channel on the underside of
the shelf. Insert a bolt into the bolt channel of the shelf. Move into position where it will line up
with the pre-drilled hole in the angle support. Put a nut on and tighten. The cantilever attaches to the
angle support and the shelf top section using the same bolt (threaded onto the bolt channel of the
shelf top section). Do the same with all of the angle supports for both shelf runners. You will notice
that the shelf is approx. ½” from the back wall. This is to enable the diagonal angle to remain in po-
sition.
Where the shelf top sections are joined to form lengths over 8’, the head of the bolt is secured so
that it fixes the edge of both joining slats. Only 1 angle support and cantilever is required on the
join.
Your shelf is now complete.