Priorities
The special signals have first priority among messages. Additionally, there are priorities among the
special signals. The following signals are shown according to their priority when they are active. In case
of a single-line display, only the message with the highest priority will be shown.
Signals per priority
1. (highest priority)
-
Overload
2.
-
Fire brigade service
3.
-
Fire/Case of fire
4.
-
Special service
5. (lowest priority) -
Out of order
With the signals of
Fire brigade service
and
fire/case of fire
, the message
out of order
will also be sent
through the controller.
All other signals are considered
informative signals
, which can also be displayed,
as long as no higher priority signal is present, and/or sufficient area is available in the displaying widget.
Some widgets allow multiline information display, to show multiple signals simultaneously.
The signals with high priority are shown first, while additional informative signals are shown in the other
lines available. We also recommend to disable by default the following signals since they are only
needed in special cases:
●
Besetzt/Occupied
●
Türe schließen/Close Door
All other signals will follow the priority sequence of their CAN-ID.
Special functions will be shown after special signals. The door status is shown in the end if the door is
CANopen compatible.
CAN Configuration
There are two options to connect the flexyPage display to the lift controller:
●
via CAN with a CANopen-Lift compatible lift controller.
●
via the in-/output of a controller, using an additional CANopen in-/output board.
© ELFIN Technology GmbH | flexyPage displays user manual | version 2.1.x | 2022-06
45
