Water Main Shut-Off Advanced User Manual
Physical Installation
Page 10
Installation Process
1. Make sure the installed valve is comfortably usable by hand before continuing
further.
2. Open both HOSE CLAMPS completely so their ends are free, insert both of
them into the slots in the MOUNTING BRACKET, and let them hang loosely.
3. Remove the protective film covering the screws on the CONTROL ARM and
spread the CONTROL ARM.
4. Make sure both the valve and the Water Main Shut-Offare in the “open”
position (where the handle is in line with the pipe, not at a right angle to it,)
and slide the CONTROL ARM around the valve’s handle.
5. Loosely tighten the hose clamps around the pipe on the opposite side of the
valve handle so it remains moveable.
6. Position the bolt of the Water Main Shut-Off directly above the bolt of the
SolidWorks Student Edition.
For Academic Use Only.
Control
Arm
Valve
Handle
Figure 5 - Sliding the CONTROL ARM around the valve handle
