4. Setup
4.1 Mounting
The C1 is equipped with four plastic feet for tabletop operation. If necessary, the feet can be easily
removed. Pry the center peg up with a small screwdriver and then pull the foot out of its mounting hole.
The C1 can be rack mounted with the included accessories. Each rack ear attaches to the side of the C1
enclosure with four 3mm screws (included).
There are three possible configurations for rack mounting
One short and one long rack ear with C1 on left side:
888
Versa DRIVE C1
COM PACT FLASH
M ODE
UP
DOWN
POWER
One short and one long rack ear with C1 on right side:
888
Versa DRIVE C1
COM PACT FLA SH
M ODE
UP
DOWN
POWER
Two C1s with two short rack ears:
888
Versa DRIVE C1
COM PACT FLASH
M ODE
UP
DOWN
POWER
888
Versa DRIVE C1
COM PACT FLASH
M ODE
UP
DOWN
POWER
For the above configuration, open the tops of both C1s and use the 4mm screws and locknuts (included) to
attach the two C1 enclosures together.
4.2 Connections
1.
Connect the data output cable from the back of the C1 into the first Versa TUBE or TILE.
•
The Serial and Local Data Outputs send identical data.
•
The Serial Data Output may be connected to a Versa TILE panel, TUBE, RAY, or Buffer Box up to
100m away.
•
The Local Data Output may be connected directly to the data input of a Versa TUBE or Versa
TILE X2, or Versa RAY up to 3m away.
2. Connect AC power from an outlet to the Versa DRIVE C1.
4. Insert a Compact Flash card into the slot on the front of the C1.
5. Power on Versa DRIVE C1.
Revised July 18, 2006
Versa DRIVE C1
Page 5 of 16
User Manual
Содержание Versa Drive C1
Страница 1: ...Versa DRIVE C1 User Manual July 18 2006 ...