5. Menu System
5.1 Navigation
The C1 can be controlled from the front panel with a simple menu system. A three digit numeric LED
display shows the current menu item and its value.
Navigation is done with the three buttons:
MENU – Steps forward through the menu modes.
UP (Λ) – Steps up through available menu items or parameter values. Press and hold for rapid scrolling.
DOWN (V) – Steps down through menu items or parameter values. Press and hold for rapid scrolling.
5.2 Selecting Modes and Modifying Parameters
To change the value for a parameter:
1.
Press MODE to scroll through the modes. The LED display will show the name of the mode and
then after two seconds will change to display the mode’s current value.
2.
When a new mode is selected, the UP (Λ) or DOWN (V) button can be pressed once, immediately to
display the current value. You do not need to wait for the display to change to the mode’s value.
3.
Press the UP (Λ) and DOWN (V) buttons to adjust the mode value.
The numeric values can roll-over in either direction betweenthe lowesst and highest values.
4.
Press MODE again to save the new value and proceed to the next mode.
After short period of inactivity (about 15 seconds), the UP (Λ) and DOWN (V) buttons go into the Lock
mode, and are disabled. This prevents accidentally changing of parameter values. If the UP (Λ) or
DOWN (V) buttons are pressed while the C1 is in Lock mode, the display will show
LOC
.
Pressing the MODE button immediately unlocks the C1. When the C1 is unlocked, it immediately goes
into the PATTERN mode:
PAt
.
While in the Lock mode, the display will revert to showing the current pattern number after a two
second delay.
5.3 Modes
When the MODE button is pressed, the C1’s display will advance to the next mode.
The Versa DRIVE C1 modes are as follows:
Pat
(Pattern): Selects the current pattern from 0-255
PLA
(Playback): Sets the playback mode to LOOP, HOLD, ONCE, BOUNCE, ALL, or PAUSE.
ID
(ID): Selects the DMX start address from 0-512
res
(DMX Resolution): Sets the DMX resolution mode to either HIGH or LOW.
brt
(Brightness): Sets the output brightness level from 1 to 10
rb
(Red Balance): Sets the White Balance level for Red from 0-63
Gb
(Green Balance): Sets the White Balance level for Green from 0-63
bb
(Blue Balance): Sets the White Balance level for Blue from 0-63
F
#
(Firmware): Displays the C1’s firmware version
Lnk
(Link): Sets the Master / Slave Link Mode to either MASTER, SLAVE, or OFF
Revised July 18, 2006
Versa DRIVE C1
Page 7 of 16
User Manual
Содержание Versa Drive C1
Страница 1: ...Versa DRIVE C1 User Manual July 18 2006 ...