Assembling the enclosure
Disconnect the DC connector, push button and buzzer from the main PCB.
Remove the protective finish from the front panel and slide it over the IN-12 nixie tubes and neon
lamps of the clock assembly and attach it to the display PCB using two M3x6 machine screws.
Remove the protective finish from the baseplate
and the acrylic support.
Mount the acrylic support to the baseplate
using an M3x12 machine screw and an M3 nut.
Do not over tighten the screw as the acrylic may
break. Use preferably a watchmakers or a
jewelers screwdriver as these will prevent you
from using too much force.
Screw two M3x8 machine screws all the way
from the bottom side through the base plate
and slide two 3 mm plastic spacers over the screw ends on the top side.
Position the main PCB on top of the baseplate so it fits over the earlier installed M3x8 screws and 3
mm spacers. Make sure the tabs on the front panel fit into the slots of the baseplate.
Attach the main PCB to the baseplate using four additional M3x8 machine screws and four 3 mm
spacers.
Содержание 150189-1
Страница 1: ...6 Digit Nixie Clock version 2 Assembly Manual Revision 1 released 2020 06 02...
Страница 3: ...Schematic and PCB Layout Main and Display Circuit...
Страница 4: ...Main PCB Display PCB...
Страница 5: ...Backlight Circuit Backlight PCB...