Elektor 150189-1, Инструкция по сборке, Страница: 19 / 21

Remove the protective finish from the acrylic GPS patch antenna mounting plates. Place the
antenna between the acrylic parts and screw everything together using two nylon M4x12 machine
screws.
Remove the protective finish from the back
panel and attach the power connector using
two M2x6 machine screws and two M2 nuts.
Watch the orientation of the panel so the wires
protrude at the right side. The engraving should
end up at the inside of the enclosure. Attach the
push button to the back panel. A 10mm socket
will come in useful here, if not pliers will do the
job. If you decide to use pliers, be careful not to
scratch the acrylic.
Attach the buzzer to the back panel using four
M2X6 machine screws and two 10 mm standoffs with internal M2 thread. Finally, attach the patch
antenna assembly to the back panel using a nylon M4x12 machine screw and a nylon M4 nut.
Connect the wires again to the main PCB and guide the tabs of the back plate through the slots of
the base plate.