Elektor 150189-1, Инструкция по сборке

Страница: 20 / 21

Remove the protective finish of the side panels. It's best to remove the small pieces of the
protective finish inside engravings first and work your way from the inside to the outside of the
panels. The protective finish can be a bit difficult to remove but keep in mind that it was needed to
protect the acrylic from laser fumes during manufacturing.
Finally guide the tabs of the side panels into the slots of the base panel. The engraving on the
panels should face the inside of the enclosure.
Remove the protective finish of the top panel and fit it over the front, back and side panels, with
the engraving again facing the inside of the enclosure. Finally screw the bottom and top panel
together using the brass tubes, threaded rods, cap nuts and nylon M4 washers.
Congratulations!!! You've finished your clock.