Lite
11
OPERATION
SUBMASTER
CONFIGURE
Submasters operate outside the control of the cross faders.
The Submaster Page Switch controls the position of the active
submaster memories.
Each page allows an individual memory to be stored on each
individual submaster. The result is 6 memories for each page.
The LED located under the Submaster slider coordinates with
the color labeled on the Submaster page switch. Submasters
without an active LED color under the handle have no memory
recorded to the Page position.
TO RECORD A SUBMASTER:
Set output levels on channel or submaster sliders in either Scene
1 or Scene 2 mode.
Select Submaster page number (Red; Yellow; Green).
Press Bump button under Submaster to be stored, then press
PROGRAM button while holding Submaster bump.
PLAYBACK
SUBMASTER OPERATION:
Select active Submaster page.
Move Submaster Slider to desired level.
Submaster outputs are controlled by the Grand Master.
Submasters operate on a 'highest takes precedence' basis with
the Crossfaders. If the channel level is set higher on the manual
output, the Submaster output will not appear.
PRESS THE BUMP BUTTON:
Submaster output level will be controlled by the Bump Master.
SELECT A NEW PAGE:
The Submaster page can be changed even when sliders are
active or inactive. This allows active Submasters from different
pages to be played at the same time. When a Submaster from
a previous page is returned to a '0' position, the current page
is automatically loaded to the Submaster.
The LED under the Submaster is coordinated with the color label
next to the page switch. An active Submaster LED indicates the
page source of the memeory.
If active LED is not illuminated, no record is established in the
Submaster.
Yellow