EL750
39 |
P a g e
per requirement. Select Level 1 and check the display stability. Go on increasing the filter
level till you get stable display readings.
To change the vibration filter level, the procedure is as follows:
Scroll to “Select Axis” in user setup, select axis ‘X.Y, Z, U’ from the soft keys. In axis
settings keys Vibration Filter & follow the steps below.
2. Press {
} key when “Vibration Filter” is highlighted.
The screen displays the Vibration Filter menu, which consist of four menus:
i) Vibration Filter – It is use to enable or disable Vibration Filter
ii) Vibration Filter Val – It is use to edit the value ranging from 1 to 20
iii) Save & Exit – It is use to save the settings
iv) Exit without saving- It is use to exit menu without saving
Note: Vibration filter function is also available for Mill & Lathe machine model.
7.5 Feed rate display:
In some application it is necessary to monitor feed rate of particular axis to ensure proper
operation. Feed rate display in top right corner of DRO counting screen as shown:
Axis Feed rate
To display feed rate of desired axis follow procedure:
1. Press {
} key.
2. Use the [
] [
] navigation keys to select “Select Feedrate Axis” menu.
3. select axis ‘X,Y, Z, U’ from the soft keys
4. Press {
} key.
After selection of desired axis, only selected axis feed rate display at top right corner of
DRO screen. If feed rate selected with “None” option then only currently moving axis feed
rate display on screen.
