EL750
37 |
P a g e
Editing sub datum coordinates
1. When in normal mode, press [
]. A list of existing jobs is displayed. The numbers
on the right indicate the number of Sub-Datum for each job.
2. Use the [
] [
] navigation to select a job.
3. Press {
} key. The information bar shows 'SDM'. It also shows (current step) /
(total number of steps).
4. Use {
} to go to the next step. Use to back up a step.
5. You can either enter the axis coordinates using axis load or move the axis to the
required position.
To use axis load, Press the [
] key to load. Enter the coordinate value using numeric
keypad and then press [
].
6. To exit Sub-Datum from graphical mode, press {
} twice.
Any changes that you make are automatically saved.
Using sub datums
1.
When in normal mode, press [
]. A list of existing jobs is displayed. The
numbers on the right indicate that number of Sub-Datums for each job.
2.
Use the [
] [
] navigation keys to select a job.
3.
Press {
} key. The information bar shows ‘SDM’. It also shows (current step)
/ (total number of steps).
4.
If you prefer to use Sub-Datum in normal display mode instead of graphical mode.
Press {
}. While in normal display mode, you can move from point to point
using the [
] [
] navigation keys. The EL750displays 'SDM - (Current Step) /
(total steps)' below axis display in the lower left hand corner. Press [
] to
return to graphical mode.
5.
Move each axis until it reaches zero. Perform the machining step.
6.
Use the [
] key to go to the next step. To back up a step, press [
]. To exit
Sub-Datum from graphical mode, press {
} key twice.
Deleting a job:
1.
When in normal mode, press [
]. A list of existing jobs is displayed. The
numbers on the right indicate that number of Sub-Datums for each job.
2.
Use the [
] [
] navigation keys to select last a job and press {
} key.
