Electrolux EILFU17GS, Техническое и сервисное руководство

Страница: 55 / 96

C Co on nd de en ns se err R Re em mo ov va all
The condenser is mounted to the drain pan by four
retaining clips.
To remove the drain pan:
1. Pull unit from its installation position.
2. Extract the screws securing the compressor
shield to the unit frame and remove from unit.
3. Recover refrigerant by using EPA approved
recovery system.
4. Remove condenser fan assembly from unit.
5. Disconnect inlet and outlet lines from
condenser. (See Figure 5-31)
6. The front of the unit will need to be raised to
access the drain pan screws.
7. Using a short phillips head screwdriver, extract
the four screws securing the drain pan to the
bottom of the unit frame.
8. Allow the drain pan to drop down. Pull drain
tube from drain pan.
9. Pull condenser tubes out of the retainers
mounted to the drain pan. Remove condenser
from unit.
10. Replace old filter-drier after installing the new
condenser.
C Co on nttrro oll M Mo od du ulle e A As ss se em mb blly y
The control module assembly is secured with
screws to the lower right side of the compressor
area.
To remove the control module assembly:
1. Pull unit from its installation position.
2. The front of the unit will need to be raised to
access the control module assembly.
3. Disconnect all wire leads from control module
assembly either at the board or at the molex
connectors. (See Figure 5-32)
4. Extract the screws securing the control module
assembly to the inner compartment side wall.
5-15
C Co om mp po on ne en ntt T Te ea arrd do ow wn n
Figure 5-31. Condenser Removal
Figure 5-32. Condenser Removal
CAUTION
U Us se e c ca au uttiio on n w wh he en n ttiillttiin ng g a a ffrre ee ez ze err u un niitt.. U Us se e
s sttu urrd dy y b bllo oc ck kiin ng g m ma atte erriia alls s tth ha att w wiillll n no ott a allllo ow w tth he e
ffrre ee ez ze err tto o rro oc ck k o orr ttiip p o ov ve err w wh he en n s se errv viic ciin ng g tth he e
u un niitt..
Cut Here
Screw
Screw