Electrolux EILFU17GS, Техническое и сервисное руководство

Страница: 14 / 96

IIn ns stta alllla attiio on n IIn nffo orrm ma attiio on n
2-6
L Le ev ve elliin ng g
The freezer must have all bottom corners resting
firmly on a solid floor. The floor must be strong
enough to support a fully loaded freezer. It is VERY
IMPORTANT for your freezer to be level in order to
function properly. If the freezer is not leveled during
installation,the door/lid may be misaligned and not
close or seal properly, causing cooling, frost or
moisture problems.
T To o L Le ev ve ell U Un niitt
After discarding crating screws and wood base, use
a carpenter’s level to level the freezer from front to
back. Adjust the plastic leveling feet in front, ½
bubble higher, so that the door closes easily when
left half way open.
D Do oo orr R Re em mo ov va all
For some installations it may be necessary to remove
the door to fit through the entrance of the installation
site.
To remove the door, follow the steps below.
1. Make sure electrical plug is disconnected from
the wall outlet.
2. Gently lay freezer on its back on a soft clean
surface.
3. Lift plastic cover off upper hinge assembly.
4. Using a 3/8” open end wrench or socket, extract
screws securing the top hinge to the unit frame.
5. Remove the toe grille by grabbing the toe grille
at the top with both hands, then pull away from
the unit until toe grille disengages from the unit.
6. Reach under bottom of cabinet and disconnect
wire leads of door connector from the cabinet
connector.
7. Using a 3/8” open end wrench or socket,
extract screws securing the bottom hinge to the
unit frame. Use a phillips head screwdriver to
extract the remaining screw from the bottom
hinge assembly.
8. Lift the door assembly off of the unit frame.
Pla s tic
Leveling F eet
Crating
S crew
Di s card The (4) Crating
S crew s And Wood Ba s e
Turn
Left To
Rai
s e
Turn
Right To
Lower
G rille/ Kickplate
Hinge S crew
Hinge Bolt
Wire
Door Connector
Cabinet Connector