Electrolux EILFU17GS, Техническое и сервисное руководство

Страница: 52 / 96

5-12
C Co om mp po on ne en ntt T Te ea arrd do ow wn n
F Fiilltte err--D Drriie err R Re em mo ov va all
The filter-drier is located in the compressor area on
the left side of the compressor. (See Figure 5-26)
To remove the filter-drier:
1. Pull unit from its installation position.
2. Extract the screws securing the fiber board
cover to the unit frame. and remove from unit.
3. Recover refrigerant by using EPA approved
recovery system.
4. Using a 3 cornered file, score a groove around
capillary tube as close to old filter-drier as
possible. Break capillary tube along score
mark from filter-drier.
5. Cut condenser outlet tube at filter-drier.
Discard filter-drier.
6. Thoroughly clean condenser outlet tube and
capillary tube.
7. Place inlet connection of filter-drier over
condenser tube approximately ¼” and solder.
8. Insert capillary tube input end into filter-drier
outlet. Do not allow tube to bottom against
screen. Solder carefully so that solder does
not plug capillary tube.
9. Install process tube adapter to filter-drier.
10. Evacuate and charge system using the
recommended procedure described under
Evacuating and Recharging in the Refrigeration
section.
11. Reassemble unit.
Figure 5-26. Filter-Drier Removal
CAUTION
O On n R R--1 13 34 4a a s sy ys stte em ms s,, tth he e s sy ys stte em m m mu us stt N NO OT T b be e
lle efftt o op pe en n tto o tth he e a attm mo os sp ph he erre e ffo orr m mo orre e tth ha an n 1 10 0
m miin nu utte es s tto o p prre ev ve en ntt m mo oiis sttu urre e c co on ntta am miin na attiio on n o off
c co om mp prre es ss so orr o oiill..
Cut Here
Cut Here