Electrolux EHTA060, Инструкция по установке и эксплуатации

Страница: 14 / 32

14
CAUTION
Do not install the appliance over 2000
meters above sea level.
E.4 Appliance space limits
• A suitable space must be left around the appliance (for
operations, maintenance, etc.).
• The passages enabling personnel to operate on the
appliance must be at least 50 cm wide, except at the rear
of the appliance.
• This space must be increased in case of use and/or transfer
of other equipment and/or means or if exit routes are
necessary inside the workplace.
• To be used to keep the correct distances indicated in the
installation diagram.
E.5 Positioning
The machine must be taken to the place of installation and the
packing base removed only when being installed.
Arranging the machine
• Wear protective gloves and unpack the machine.
• Lift the equipment with a lift truck, remove the base and
position it the place of use.
• Carefully remove the protective film from the outer panels
without tearing it, to avoid leaving traces of glue.
• Adjust the equipment by turning the special adjustable feet
and making sure it is perfectly level, both length wise and
crosswise.
• The appliance must be fixed to the floor using the two
clamps supplied.
– Accessing the appliance bottom panel.
– Fit the clamps on feet as shown in supplied technical
sheet.
– Screw the appliance steadily to the floor using hole
clamps.
E.6 Extraction hood
For models without Energy Saving Device (ESD), make sure
to install an extractor hood to remove the steam produced by
the machine.
For models
with Energy Saving Device (ESD), it is not
necessary to install an extractor hood unless the current
regulations in the country of use require it.
The hood air flow must be calculated taking into account the
type of installation and the work environment where it is
installed.
In any case, an air flow rate of between 1000 m
3 /h and 1500
m 3 /h is recommended.