Electrolux EHTA060, Инструкция по установке и эксплуатации

Страница: 20 / 32

20
H BEFORE FIRST USE
H.1 Manual activation
NOTE!
To obtain excellence washing performance, use
detergent, rinse aid and descaling agent sug-
gested by Electrolux Professional. In the Electrolux
Professional web site, open the “Accessories and
Consumables“ web page and navigate into the
dishwashing equipment tab to order most suitable
detergents and accessories.
Whenever the detergent containers are replaced, it may be
necessary to activate the dispensers manually in order to fill
the hoses and eliminate any air. Simultaneously press the
buttons, as shown in the figures below. If necessary, repeat
this operation several times.
Detergent dispenser Rinse-aid dispenser
H.2 Setting the dispensers
All operations should be carried out with the appliance
switched on, the hood open and no cycle selected.
Press, together, the “On/Off“ and “Wash cycle 1“ buttons for 5
seconds to access the programming mode and the display
shows the parameter
USr
.
Press the button “L“ (refer to F.1 Control panel description )
twice to access the detergent and rinse aid adjustment
parameters.
The display shows
dun
which is the first parameter of the
dispenser family:
Parameter description Value
1
Unit of measure
of dispensers
(
G-L
= g/l or
SEC
= seconds)
dun G-L
Initial amount of
detergent dIn 2.00 g/l
Initial amount of
rinse-aid
rIn
0.12 g/l
Amount of deter-
gent during the
cycle dEt 2.00 g/l
Amount of rinse-
aid during the
cycle rAi 0.12 g/l
1. The values given in the table refer to the factory-settings.
• Press the “Wash cycle 1“ and “Wash cycle 2“ buttons to
select the parameter to modify.
• Press the button “L“ to modify the parameter value.
• Press the “Wash cycle 1“ and “Wash cycle 2“ buttons
respectively to decrease/increase the value.
• Press the button “L“ to store the set value and return to
parameter selection (see point 1).
For example, to adjust the parameter
dIn
, proceed as
follows:
1. access the programming mode;
2. access the dispenser family;