Electrohome WINSTON EANOS501 Скачать руководство пользователя

Страница: 6 / 17

- 10 -

- 11 -

RAISING AND LOWERING THE LID IMPORTANT

To open the lid, raise it as far as it will go until the lid support bracket ‘locks’ in the open position. To close
the lid, lift it upward slightly until the lid support bracket unlocks’, and then gently lower the lid.

TO AVOID DAMAGING THE CABINET OR THE LID, NEVER FORCE THE LID CLOSED. ALWAYS RAISE THE LID

TO RELEASE THE LID SUPPORT BRACKET.

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber ‘feet’ to prevent the product from moving when you operate
the controls. These ‘feet’ are made from non-migrating rubber material specially formulated to avoid
leaving any marks or stains on your furniture. However, certain types of oil based furniture polishes, wood
preservatives, or cleaning sprays may cause the rubber ‘feet’ to soften, and leave marks or a rubber residue
on the furniture. To prevent any damage to your furniture we strongly recommend that you purchase small
self-adhesive felt pads, available at hardware stores and home improvement centers everywhere, and
apply these pads to the bottom of the rubber ‘feet’ before you place the product on fine wooden furniture.

HEADPHONES

For private listening, plug headphones (not included) into the headphone jack on the front panel of the
player. The speakers will be disconnected when headphones are plugged in.

LISTENING TO THE RADIO

1. Flip the ON/OFF switch to the “–” position to turn the unit on.
2. Rotate the AM-FM-CD-PH-AUX switch to the AM or FM position as desired.

The backlight behind the AM/FM dial will light.

3. Rotate the tuning control to select a station. If tuned to a strong FM station,

the FM Stereo indicator will light and the sound will be in stereo.

4. Rotate the VOLUME control to set the volume as desired.
5. To turn the unit OFF, flip the switch to the “O” position.

AM Note:

The AM antenna is inside the cabinet. If reception is unsatisfactory try repositioning the cabinet

slightly for the strongest signal.

FM Note:

The wire antenna is located on the back cabinet. If necessary adjust the position and direction of

this antenna for the best reception.

AUX IN OPERATION

Listen to music via the AUX IN input by connecting your MP3 player or smartphone. Rotate the AM-FM-CD-
PH-AUX switch to AUX mode. Insert the 3.5mm Aux cable (not included) into the corresponding AUX IN Input
at the back of your system. Connect the other end of the cable to your device (item A). Adjust the volume
using the VOLUME CONTROL knob on the system’s control panel.

Navigate your music files using your device.
Disconnect your device when not in use.

INSERTING AND PLAYING A CD

1. Flip the ON/OFF switch to the “–” position to

turn the unit on. The LED power indicator will light.

2. Rotate the AM-FM-CD-PH-AUX switch to the CD position. ‘- -’ will appear in the display.
3. Press the OPEN/CLOSE button to open the CD tray. Place a CD in the tray, with the printed label facing up.

Press the OPEN/CLOSE button again to close the CD tray.

4. The disc will spin for a few seconds while the player is reading the disc and the total track number will

appear in the display. Press the PLAY/PAUSE button to start playing the first track of the disc. Adjust the
VOLUME control to set the volume as desired.

5. To skip forward or backward through the tracks on the disc, press the SKIP REV or SKIP FWD buttons. To

search forward or backward through the tracks, press and hold the SKIP REV or SKIP FWD button.

6. Press the PLAY/PAUSE button to pause playback. The PLAY/PAUSE indicator will blink in the display. Press

again to resume playback. When the disc is through playing, it will stop rotating.

7. To stop playback entirely, press the STOP button.

• As each track is played, the track number is shown in the display.

• The PLAY/PAUSE indicator will appear in the display when CD is playing.

RANDOM PLAYBACK

During CD-R/RW stop mode, press the RANDOM button once; the unit will then play the tracks in a random
order. Press the STOP button to cancel the random setting.

• During RANDOM playback, press the REPEAT button once to activate repeat 1 playback.

• The player will play your selected track repeatedly until you cancel the REPEAT function by

pressing the REPEAT button twice, the repeat LED indicator will go out.

PREPARATION FOR USE

EANOS501/EANOS502 OPERATION DIFFERENCE

POWER ON/OFF

1, Press the power ON/OFF button on the back

of the unit to the position’-’ to

turn on the unit;

2, Press the power ON/OFF button on the back

of the unit to the poistion’0’to

turn off the unit;