76
Installation Manual
Installing System / Commissioning
3.4.2. ATTACH FRONT COVER
1. The front cover assembly requires attaching the bonding cable
using the wing nut and PEM location, as pictured below (green
cable).
2. Wire the small four pin black connector coming from PowerHub 2
for Rev. 1 cable and two, small two pin, one white and one black,
connectors for the Rev. 2 cable and connect the other end to the
main enclosure front cover display.
WARNING!
Ensure 4 pin connector is connected correctly the first
time. Otherwise it will short the display board and disrupt the
entire CANbus communications of the PowerPod 2. If shorted,
leave the front unit disconnected to allow coms to work properly.
3. Place the front cover back onto the mounted main enclosure and
ensure it is secure.
4. Once the cover is on, tighten the four screws on the front cover.
