EN
11
Initial settings in the electronic block – water heater basic characteristics and time and date.
Initiating water heater basic characteristics
When the water heater is plugged in power supply network, but it is off from the electronic
block button ON/OFF, when pressing simultaneously the buttons F and
Г
and holding
them for more than 4 seconds, the screen shall display the electronic block model and its
software version.
By briefly pressing the F button, the display shows the initial setup menu Settings.
The electronic block is factory set to operate a water heater with 80 liters enamel tank and
power of 3 kW. If your device is different, you need to enter its data .
The field for setting blinks. You can increase and decrease the values of blinking field with
buttons
▲
and
▼
. You can move from one field to next on for setting by pressing the button
Г
. The values to be put in place for water heater power and volume of the tank are those indicated on the metal
label with the unit data affixed to the bottom cover of its outer casing. You can select the field indicating presence of
the safety anode in the default settings of the electronic unit, if the unit is a water tank with a protective glass-enamel
coating and additional corrosion protection is embedded. By pressing the button F you exit setup and store the
entered values by which the unit enters in switched off position.
Setting the time and date
To set the current date and time it is necessary that the unit is in operation mode (by
pressing ON/OFF) then press and hold the F button for at least 2 seconds. The display
shows the submenu Next start. With the next pressing of the F button you enter the
submenu Set time (for adjustment of hour and minute), where flashes the actual unit hour.
By using the buttons
▲
and
▼
you can change the value, then you can move to the next
field with the button
Г
.
Recording the setting and move to the next submenu Set date (setting the date) is carried
out by pressing the button F. Using the same buttons
▲
,
▼
and
Г
allows you to adjust the
date and by pressing the button F you move to the next setting mode for delayed start. With
some more consecutive clicks on F button, you exit from the settings mode and return to
the operating mode in which the unit was before the settings procedures.
Changing the temperature to heat water
In Heat mode pressing the buttons
▲
and
▼
allows you to change of preset temperature to
which the water will be heated. By pressing a button the temperature changes by 1 degree ,
while keeping the button pressed a smooth increase or decrease of the temperature set
takes place. After releasing the button the temperature value starts to flash.
If no pressing of a button after about 10 seconds takes place the selected temperature
value is stored in unit memory and the display shows the temperature of the water at the moment .
The same happens immediately when pressing the button
Г
.
The temperature set to which the water will be heated is shown at the bottom left of the display.
Further configuration of the electronic unit
Start time of day and night tariffs
For the implementation of additional and advanced features the electronic control unit provides you may adjust the
start periods with day and night electricity tariff. You should keep in mind that with the transition from winter to
summer time and back, the early hours of day and night tariff change and the necessary entries have to be updated.
You may access the setting mode from the operation of the unit after pressing and holding for more than 2 seconds
the button F, followed by repeated short presses of the same button until on the display
appears the following image:
By using the buttons
▲
and
▼
you may change the value of the blinking box and move to
the next field by pressing the button
Г
. By pressing the button F you memorize selected
settings and move to the next submenu Contrast.
