Application manual
Presence / movement sensors EK-DF2/DG2-TP
Rev. 1.2 - 2020-02-06
MAEKDF2DG2TP_EN
© Ekinex S.p.A.
– All rights reserved
Pag. 14
Parameter name
Conditions
Values [Default]
If enabled, each channel can also be controlled from the KNX bus through communication objects #5-6-
7-8.
For Light control channels, the CO (which is of 1-bit Switch type) also controls the dimming function.
This pushbutton is required to switch those channels On for which semi-auto mode is selected.
Lux / Time /
Sensitivity(Meter)/
STBY selected by
Device type = Master
ETS
IR
Selects the source for the main device parameters: Brightness threshold, activation delay, sensitivity,
standby delay. If the source is "ETS", the IR remote has no effect on these parameters.
This setting is only relevant for the two Light Control channels (C1-C2).
Test mode
Device type = Master
Disable
Enable
If enabled, starts the test mode at the end of the download. Test mode automatically exits to normal
operation after 10 min. or upon command from the IR remote.
Sensor sensitivity
Maximum
High
Medium
Low
OFF
Used to increase or decrease the sensitivity of the
PIR according to user’s requirement.
This setting is available both for master and slave configurations.
LED turns on when PIR is
triggered
Disable
Enable
When enabled, the red LED will turn on for 1 s every time movement is detected. This indication can be
suppressed; however, all other indication functions of the LED remain enabled.
13.3 Menus: Light control output C1 / C2
Following parameters are repeated for each of the two Light Control channels C1 and C2
.
Although not specified below, these options are only listed if the corresponding channels are active.
Parameter name
Conditions
Values [Default]
Auto / Semi-auto select
Device type = Master
Auto
Semi-auto
The automatic mode controls both switch-on and switch-off; the semi-automatic mode only controls
switch-off after a manual switch-on through the external control pushbutton.
Output type
Device type = Master
Switching
Dimming
Switching mode is used to control an On/Off actuator through a Switch-type object; in this mode, Standby
function and Constant light control are not available.
Dimming mode controls a dimming-capable actuator through an Absolute dimming object (for the
Standby function) and a Relative dimming object (for Constant light control).
Dimming value during ON
phase
Device type = Master
Output type = Dimming
1...100%
[100%]
