Eiki LC-VC1, Руководство пользователя

Страница: 37 / 44

This function turns Projection Lamp off
when projector detects signal
interruption and projector is not used for a certain period in order to
reduce power consumption and maintain the Lamp-life. (This projector is
shipped with this function ON.)
Power Management function operates to turn Projection Lamp off when
the input signal is interrupted and projector is not operated over 5
minutes. This function operates as follows;
1. When the signal is interrupted, “No signal” and the counting down
display appears (for 5 minutes).
2. When Projection Lamp turned off, READY Indicator turns off.
Cooling Fans operate and Projection Lamp is turned off for 90
seconds. (During this “Cooling Down” period, projector cannot
be turned on.)
3. When Projection Lamp has cooled down, READY Indicator flashes
and Projection Lamp can be turned on again (Power Management
mode).
In this Power Management mode, Projection Lamp is automatically
turned on when the input signal connected or projector is operated
with any button on the Top Control or on the Remote Control Unit.
When this function is “On,” projector is automatically turned on just by
switching MAIN ON / OFF SWITCH on.
Note; Be sure to turn projector off properly (refer to the section
“TURNING OFF THE PROJECTOR” on page 20.). If projector is
turned off in the wrong steps, On Start function does not operate
properly.
This projector has two different remote control codes; the factory-set
normal code (Code 1) and the secondary code (Code 2). This switching
function prevents the remote control operation mixture (jam) when
operating several projectors or video equipment together. When operating
projector in “Code 2,” both projector and Remote Control must be
switched to “Code 2.”
To change the code of Projector:
Set the Remote control in the SETTING MENU to “Code 2.”
To change the code of the Remote Control:
Press both MENU and NORMAL buttons on the Remote Control
Unit together for over 10 seconds.
After changing the code, make sure the Remote Control operates
properly.
To return to the normal code (Code 1), operate both projector and
Remote Control in the ways above again.
NOTE: When batteries of the Remote Control Unit is replaced, the
remote transmit code automatically returns to the normal code
(Code 1).
This function is used to reset Lamp
Replace Counter. When replacing Projection Lamp, reset Lamp Replace
Counter by using this function. Refer to page 39 for operation
.