Eighteeth UltraMint, Руководство пользователя

Страница: 18 / 35

5 Product function and use
Page 18 / 35
NOTE
1. Keep the device clean before and
after use.
2. Before each use, always check that
the device is placed on a secure and flat
surface. And adjust the water flow to the
maximum, and then start the device to
work for about 10 seconds in order to
eliminate the residual liquid in the liquid
circuit.
3. The operator should take sufficient
protection (such as wearing goggles,
face mask, etc.) to prevent cross
infection. Use of an antiseptic mouth
rinse prior to procedure and use of a
high volume evacuator during the
scaling procedure are recommended.
4. The use of the product must meet the
requirements of the relevant operating
specifications and relevant regulations
of the treatment department, and is
limited to the use of trained
professionals (such as dentists) in the
hospital or clinic.
5. Do not screw the tip or pull out the
handpiece while the machine is running.
6. The tip must be tightened and there
must be fine spray coming out from the
tip when operating. Refer to the user
manual of tips for detailed operating
instructions.
7. Change a new one when the tip or
handpiece is damaged or there are
visible signs of wear.
8. Do not twist or rub the tip.
9. Do not use impure water sources, and
never use saline instead of pure water.
10. If use the water source without
hydraulic pressure, the water
surface should be 1 meter higher
than the head of the patient.
11. Do not pull the handpiece cord
with force to avoid damage to the
tail wire.
12. Do not knock or rub the
handpiece.
13. After operating, turn off the
power switch and pull out the power
plug.
14. Always use original parts. Using
non original instruments may
damage the device, and operator or
patient may be injured.
15. No modification shall be made
on this product.
16. The ultrasound power must be
adjusted in accordance with the tip
used and the required treatment.
17. Always check that the cords or
cables will not rub against the front
face during the operation since this
could eventually modify the
selected settings.