The Telebox PLC offers the possibility to be switched into the so-called "Transparent Mode".
This gives the option to control all data of the scale with a PC remote. In addition, as described
above, all data are stored with
Print, Add
and
Total.
By the calibrated flash a further
processing of the data with the PC is possible. In addition, the scale can be controlled remotely
via the remote commands. In addition, it is possible to perform a switchover between the two
programmed scales. To set the Telebox to this state, parameterize P15 and P6 to 1 in the
setup. Optionally, the Telebox PLC can also be set temporarily to this mode with the
commands listed below.
The 7-byte control commands that intervene on the parameterization of the telebox are
immediately confirmed by the telebox via return command. Positive, or after an error also
negative.
With activated transparent mode it is possible to control the channel of the radio modem from
outside. This gives you the option to temporarily select any radio channel in the telebox
without any problems. Please note that data is only received here if the scale selected on this
channel also has the identical carriage number as is stored in the Telebox PLC (parameters 2
and 13). The control commands for the channel change for High Range radio (500m) and Low
Range radio (100m) are different and not compatible.
If you are working in the Grey Box Mode, you must ensure that weighing data from the scale
is received immediately after a successful channel change. If this is not desired, the scale must
be switched off for the channel change.
Remote commands:
xx 31 CE 03
Key 1 Tare *
xx 32 CD 03
Key 2 Print *
xx 33 CC 03
Key 3 0 digits *
xx 34 CB 03
Key 4 Add *
xx 35 CA 03
Key 5 ½ *
xx 36 C9 03
Key 6 Total *
xx 37 C8 03
Key 7 Test *
xx 38 C7 03
Key 8 Off *
xx 39 C6 03
Key 9 Activate peak value or pouring rate/sec., deactivate *.
xx 30 CF 03
Key 10 Pre Tare *
