4F 4B 03 0D 0A
ASCII = OK ETX CR LF positive response Telebox PLC command was
recognized and is executed. Sending of the SD card data was
successful and has been completed.
45 52 xx xx xx 03 0D 0A
ASCII = ERRxxxx ETX CR LF negative response Telebox PLC command
was not recognized or an error occurred during data processing.
Where xx or x stands for the error number. See table error handling
For more information on the control commands, refer to Chapter 6. "Transparent Mode".
The measurement data are evaluated with the PC via the SD card.
Procedure:
Switch off the Telebox PLC. The SD card is located on the right side of the Telebox SPS,
protected under a metal cover. You can remove the SD card by tapping on it. Using an SD card
reader, the data can be transferred to a PC. The MD010106.EHP file contains the stored
weighing data. Open the file with the text editor.
1
Memory number tens of thousands place
2
Memory number thousands digit
Figure 4 -Format of the MD010106 file
