EFKA FP220A5911
33
Parameter 322 = 2 Seam or pattern interruption by thread trimming:
The seam can be interrupted by pressing the
pedal to pos. –2 and thread trimming, even if the thread trimmer is Off. Then the program switches
back to the
first
seam of the selected pattern.
Sewing foot lift functions if TEACH IN is On:
After power on the sewing foot is down even if sewing foot lifting after thread trimming is On on the control panel. the
sewing foot can be lifted by pressing the pedal to pos. –1 or –2. If sewing foot lifting is On at the seam end (righthand
arrow above the 6 key on the V820 control panel On), the sewing foot is lifted after completing the seam. After having
pressed the pedal to pos. 0 (neutral) the control switches to the next seam, and the sewing foot remains lifted until sewing is
started. Whether or not the sewing foot is On or Off does not influence the seam end in the new seam.
Automatic sewing foot lift with pedal forward at the seam end, if light barrier or stitch counting is On:
Parameter 023 = 0
Automatic sewing foot lift Off
Parameter 023 = 1
Automatic sewing foot lift On
Parameter 023
6 key (righthand arrow)
Sewing foot with pedal
Sewing foot with
forward after the seam
pedal = 0
end
0
0
Off
Off
1
0
On
Off
1
1
On
On
0
1
On
On
Functions
Parameter
Sewing foot lifted after power On, or as programmed
(FLn)
323
This function is active only if TEACH IN is On.
Parameter 323 = 0
After power On, the sewing foot lift function works as programmed.
Parameter 323 = 1
The sewing foot is always lifted after power On, even if automatic sewing foot lift is not
programmed.
Functions
Parameter
TEACH IN
On/Off
(ti)
324
Using this parameter, TEACH IN can be enabled and disabled without control panel. However, TEACH IN programming
is possible only with the V820 control panel.
When the V820 is connected, TEACH IN is enabled and disabled by means of the 0 key.
Functions
Parameter
Erasing all
TEACH IN
data
(cti)
325
!
Input code number 3112 after power On
"
Press the
E
key
!
Input parameter 325
"
Press the
E
key
!
Input 3112
"
Press the
P
key
!
The display briefly shows “
deleted
“, and a short audible signal is issued.
"
Press the
P
key
!
All TEACH IN programs have been erased!
"
Press the
P
key
!
The sewing process is enabled again.
!
If you press the
0
key now, the display shows “
no ProG“
