EFKA FP220A5911
58
Machine run blockage in the start backtack / start stitch condensing:
The start backtack / start stitch condensing is interrupted by opening and/or closing the switch.
!
Stop in the basic position
!
Needle up is not possible
!
Sewing foot lift is possible
!
After disabling of the machine run blockage, the seam will be continued with the section following the start backtack /
start stitch condensing
Machine run blockage in the end backtack / end stitch condensing:
The end backtack / end stitch condensing is interrupted, and the seam is completed by opening and/or closing the switch.
!
Sewing foot lift is possible
New start after machine run blockage
Function
with
or
without
control panel
Parameter
New start after machine run blockage
(Pdo)
234
Parameter 234 determines how a new start is possible after closing and/or opening the switch.
Parameter 234 = 0
New start after disabling machine run blockage without influence by the pedal. This setting is
applicable, for example, to automats.
Parameter 234 = 1
New start after disabling machine run blockage only if the pedal is in position 0 (neutral).
11.13 High Lift for Walking Foot Signal Output M6 / Flip-Flop 1
Function
with
or
without
control panel
Parameter
High lift for walking foot On/Off
(hP)
137
Signal “high lift for walking foot M6” when key is closed/open
(ihP)
263
High lift for walking foot is effective only if input function 13 or 14 has been selected by means of parameters 240...249
and parameter 137 = 1. With all other settings high lift for walking foot is ineffective. The signal “machine at standstill” is
issued at the corresponding output (M6). Select by means of parameter 263 whether the key is to be active when open or
when closed.
Parameter 263 = 0
Signal “high lift for walking foot M6” is issued when key is closed
Parameter 263 = 1
Signal “high lift for walking foot M6” is issued when key is open
11.13.1
High Lift Walking Speed
Function
with
or
without
control panel
Parameter
High lift walking speed
(n10)
117
11.13.2
High Lift Walking Speed Run-Out Time
Function
with
or
without
control panel
Parameter
High lift walking speed run-out time
(thP)
152
