Efiamma Good 10 C, Руководство по эксплуатации и обслуживанию

Страница: 47 / 156

GOOD 10 C- GOOD 12 C
Use and maintenance manual
Page 47
Rev.0 01/03/2019
EN
The data shown below is indicative and not a commitment and may change based on the pellet type used. Efiamma reserves the right to make any changes in order to
improve product performance.
Technical Specifications
Minimum distance from flammable materials
MODEL Good 10 C
R = right side 150 mm
L = left side 150 mm
B = back 100 mm
A = front 800 mm
DO NOT INTRODUCE INTO THE TANK ANY OTHER TYPE OF FUEL OTHER THAN PELLET CONFORMING TO
THE PREVIOUSLY EXPLAINED SPECIFICATIONS.
Unit of
measurement
Good 10 C Good 12 C
Height mm 1136 1216
Width mm 454 455
Depth mm 614 614
Weight kg 105 115
Smoke exit pipe diameter mm 80 80
Air inlet mm 50 50
Ducting mm 80 80
Maximum heat volume m3 240 285
Thermal power | reduced - nominal kW 4,8 - 10,0 4,8 - 11,8
Absorbed electrical power W 275 275
Power supply V - Hz 230 - 50 230 - 50
Tank capacity kg 20 24
Min-max autonomy h 20 - 9 24 - 9
Performance | reduced - nominal % 91,3 - 87,1 91,3 - 87,4
CO at 13%O2 | reduced - nominal % 0,019 - 0,010 0,019 - 0,004
Smoke mass | reduced - nominal g/s 4,6 - 8,9 4,6 - 9,3
Minimum draft Pa 10 10
Smoke temperature | reduced - nominal °C 117 - 181 117 - 195
Consumption | reduced - nominal Kg/h 1,0 - 2,3 1,0 - 2,7
Preliminary operations
Electrical connection
What needs to be checked before turning on the stove
Check that all components that may burn have been extracted and removed from the combustion chamber or glass (instructions or
various adhesive labels).
Before turning on the equipment, check correct positioning of the brazier on its support base and that the door and the ashes drawer
are closed properly.
Loading pellet
The fuel is loaded by opening the door and inserting pellet from the upper part of the stove. During the loading phase, avoid that the
pellet bag comes in contact with hot surfaces. Do not let the pellet bag fall hard on the stove.
Connect the power supply cable, first on the back of the stove and then to an outlet on an accessible wall.
Connect the stove to an earthed electrical system
Only plug the stove’s power cable in after it has been installed and assembled, and make sure it is accessible
after installation.Be careful not to let the power cable (or any other cables outside the equipment) touch any hot
parts. The switch in figure I/O must be positioned on I to power the stove. If there is no electrical power, check
the state of the fuse located in the box under the switch (4A fuse). During a period of non use, it is recommended
to remove the stove power supply cable.
DO NOT INTRODUCE INTO THE TANK ANY OTHER TYPE OF FUEL OTHER THAN PELLET CONFORMING TO
THE PREVIOUSLY EXPLAINED SPECIFICATIONS.
MODEL Good 12 C
R = right side 200 mm
L = left side 200 mm
B = back 100 mm
A= front 800 mm
B
R
L
A