EFI Fiery ES IC-418, Конфигурация и настройка, Страница: 21 / 243

Note: If a bootable USB flash drive is inserted in the Fiery ES, remove it before rebooting. Non-bootable flash drives
do not interfere with the boot process.
Important:
Before you restart, reboot, or shut down the Fiery ES, we recommend that you confirm the reason
with your local network administrator or with technical support.
If the Fiery ES must be powered off for any reason, always shut it down correctly by following the shut down
instructions provided in this document.
Protect the Fiery ES from power interruptions. Ensure that the power cable remains as configured by the
service technician and that the cable is protected as required by a surge suppressor, line conditioner, or
uninterruptible power supply (UPS).
Power on the Fiery ES
1
If the printer is off, press the main power switch on the printer to turn it on.
2
Make sure that the Fiery ES power cable is connected to power as it was configured by the service technician.
3
Make sure the Fiery ES power switch is in the ON (|) position.
Note:
Depending on the market region, the power supply cover may be attached to the Fiery ES chassis, and the
power switch may not be accessible. In this case, the power switch is in the ON (|) position by default.
4
Press the Fiery ES power button once.
The power supply automatically senses the correct voltage. Allow startup to proceed without interruption.
5
Wait for the Fiery ES to power on and reach Idle.
Restart, Reboot, or Shut Down the Fiery ES
You can restart the Fiery ES software, reboot the Fiery ES, or shut down the Fiery ES through the following methods:
•
Command Workstation: Restart or reboot
•
Printer control panel: Restart, reboot, or shut down
Important:
Avoid using the power button to shut down the Fiery ES, as doing so may cause the system to
operate unpredictably. If you need to shut down the Fiery ES, we recommend shutting down through the
printer control panel. Use the power button only if the printer is off or the system is unresponsive to keyboard
or mouse actions. In this case, briefly press and release the power button.
Restart or reboot from Command WorkStation
1
Make sure that the Fiery ES is not receiving, processing, or printing any files.
If the system has just finished processing, wait at least five seconds after the system reaches Idle before you
proceed.
Configuration and Setup
Integrating the Fiery ES into your network
21