EFI Fiery ES IC-418, Конфигурация и настройка, Страница: 15 / 243

Login timeout
Specify when the Fiery ES times out after you log on.
When you finish making changes, save the changes. The Fiery ES requires a reboot in order for any
Setup
changes to
take effect.
Ethernet Speed
Choose the appropriate speed of the network.
You can allow the Fiery ES to detect automatically the speed in any of these cases:
•
The network speed is unknown.
•
The network environment is mixed.
•
The network uses 1 Gbps.
Get IP Address Automatically
Select to automatically obtain an IP address for the Fiery ES. Clearing this check box activates the fields for entering
the IP Address, Gateway Address, and Subnet Mask.
IP Address
Enter the Fiery ES IP address for Ethernet.
This IP address, unlike an IP address set automatically, remains the same if you restart the Fiery ES. You must
change the default to a valid address for your network.
Gateway Address
Set the gateway address for printing with TCP/IP on your network.
Subnet Mask
Set the subnet mask for printing with TCP/IP on your network.
Note:
Before proceeding, confirm the subnet mask setting with your network administrator.
802.1x Setup
The Fiery ES can seek authentication from an 802.1x authentication server (such as a RADIUS server), often through
an intermediate access point (an authenticator).
The Fiery ES seeks this authentication at startup, or when the Ethernet cable is disconnected and reconnected. If the
Fiery ES is successfully authenticated, it is allowed access to the network.
Configuration and Setup
Setting up from the printer control panel
15