Chapter 3: Programming
SIGA-REL Technical Reference Manual
39
Programming the SIGA-REL in the 3-SDU
Adding the SIGA-REL to the database
WARNING:
This information was prepared for users who are proficient in every
aspect of 3-SDU programming. Do not attempt to program the SIGA-REL if your
certification is not current. Incorrect programming may result in loss of life,
serious injury, or property damage.
The SIGA-REL is a single module with six serial numbers. Addresses will differ
for each installation, but they must be consecutive.
Note:
If you are adding other Signature Series devices to the project database,
add the SIGA-REL last. Adding devices after the SIGA-REL may disrupt the
addressing scheme.
The SIGA-REL has six addressable circuits. To add the SIGA-REL to the project
database, you must add three SIGA-RELs. The first SIGA-REL is for the abort
switch and manual release switch circuits, the second for the two release circuits,
and the third for the two prerelease circuits.
Note:
You cannot have more than 10 SIGA-RELs on one Signature loop.
The SIGA-REL provides only one serial number label. When you scan in the
SIGA-REL, only the first two serial numbers appear in the database.
WARNING:
Do not configure the third and fifth SIGA-REL addresses as common
outputs or audio amplifiers. Any off-normal condition activates the automatic
release sequence if these addresses are common outputs. The Drill switch
activates the prerelease and the release circuits if they are audio amplifiers. You
must select the device types and personality codes exactly as prescribed in
Table 18.
To add the SIGA-REL to the database:
1. Use the Signature Series Configuration dialog box to add three SIGA-REL
modules:
Device type = Monitor
Model = SIGA-REL
Personality code = 3
Quantity = 3
2. Scan or enter the SIGA-REL serial number label in the first address slot.