EdilKamin LAGUNA M 25, Инструкция по установке, эксплуатации и обслуживанию

Страница: 79 / 272

- 79
-
ENGLISH
COMBUSTION
During combustion in
NORMAL
status, the system can pass to
MODULATION
if:
• the smoke temperature exceeds the optimal value of the operating condition.
• or the temperature of the water in the boiler exceeds the value of the thermostat set.
MODULATION
has the purpose of reducing combustion to gradually reach the water thermostat
value set or lower the smoke temperature. Modulation brings the system to power 1.
During combustion in
NORMAL
status, the system can pass to
SWITCH OFF
if:
• the smoke temperature goes below 50°C;
• the smoke temperature for each operating power goes below the minimum threshold.
During combustion, the system can go to
SWITCH OFF
and
SAFE
status if:
• the smoke temperature exceeds the factory threshold set.
• the boiler water temperature exceeds 85°C.
During combustion, the system can go to
STAND-BY
status if:
• the buffer temperature is over the SET temperature for 2 minutes.
On pressing the key, the boiler in whatever status, goes to
SWITCH OFF
.
This phase has the purpose of bringing the smoke temperature under the value of the boiler off
50°C, once complete the system cleans the crucible and the exchangers and then goes to
OFF
status.
LOCK STATUS
This status is present during boiler operation or also with the system off if one of the errors among
those described on page 68 occurs.
To reset the system lock status, you need to:
• solve the error that occurred (e.g. safety thermostat activation on boiler temperature reset).
• if the alarms are no longer present, press the key for 3 seconds and the system switches
OFF.
INSTRUCTIONS FOR USE
Friday 15:29
Switch off
Block
Friday 16:23