75
Scout 320 REV 3:2018
Parameter description: This is an end of bar retreat delay. Once the End Of
Bar signal is on and the lathe collet opens the bar
pusher will delay the set time prior to returning home.
Setting method: Input the necessary delay time.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~9.9 seconds
Setting value:
Parameter description: This is also known as impulses on. During loading of
a new bar the lathe spindle can be commanded to
rotate if wired to do so.
Setting method: Input required time.
Note: Normally not used on Swiss headstocks. Lathe must
support function.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~9.9 seconds
Setting value:
Parameter description: This is also known as impulses off. During loading of
a new bar the lathe spindle can be commanded to
stop rotating if wired to do so.
Setting method: Input required time.
Note: Normally not used on Swiss headstocks. Lathe must
support function.
Previous page
Next page
Home page
3.7XL Generally value:
Setting range:
0~9.9 seconds
Setting value:
