Edge-Core ES3510MA-DC, Руководство по управлению, Страница: 337 / 1098

C
HAPTER
14
| Security Measures
Configuring Port Security
– 337 –
C
OMMAND
U
SAGE
◆
A secure port has the following restrictions:
■
It cannot be used as a member of a static or dynamic trunk.
■
It should not be connected to a network interconnection device.
◆
The default maximum number of MAC addresses allowed on a secure
port is zero. You must configure a maximum address count from
1 - 1024 for the port to allow access.
◆
If a port is disabled (shut down) due to a security violation, it must be
manually re-enabled from the Interface > Port > General page
( page 127 ).
P
ARAMETERS
These parameters are displayed:
◆ Port – Port number.
◆ Action – Indicates the action to be taken when a port security violation
is detected:
■
None : No action should be taken. (This is the default.)
■
Trap : Send an SNMP trap message.
■
Shutdown : Disable the port.
■
Trap and Shutdown : Send an SNMP trap message and disable the
port.
◆ Security Status – Enables or disables port security on the port.
(Default: Disabled)
◆ Max MAC Count – The maximum number of MAC addresses that can
be learned on a port. (Range: 0 - 1024, where 0 means disabled)
The maximum address count is effective when port security is enabled
or disabled, but can only be set when Security Status is disabled.
W
EB
I
NTERFACE
To configure port security:
1.
Click Security, Port Security.
2.
Set the action to take when an invalid address is detected on a port,
mark the check box in the Security Status column to enable security for
a port, and set the maximum number of MAC addresses allowed on a
port.
3.
Click Apply