©2011 Edelbrock LLC
Part #1580 & 1585
Brochure #63-1580
Rev. 1/11 - AJ/mc
Edelbrock 4.6L Ford Supercharger System
for 2005 and later Mustang GTs
Installation Instructions
Page 7
I. Hood Removal
1. Use a panel puller to pry off two of the push-pins
holding the hood insulator in place on the passenger side,
then reach behind the insulator to disconnect the washer
hose from the T-junction at the passenger side nozzle.
Detach hose retaining clip, then remove these two pins.
Pull hose off here.
(Insulator fully removed for illustrative purposes.)
2. Have an assistant support the hood while a 10mm
socket is used to remove the four bolts attaching it to its
hinges. Lift the hood off the vehicle and set it aside.
II. Battery Removal
3. Use an 8mm socket to loosen the negative battery
terminal clamp and remove it. Tuck it to the side to
prevent any accidental contact with the negative battery
terminal.
4. Use a 10mm socket to remove the nut on the positive
battery terminal that retains the alternator power wire.
Detach this wire from the terminal, then loosely reinstall
the nut.
5. Use an 8mm socket to loosen and remove the positive
battery terminal clamp, then tuck the wire over to the
side.
6. Pull the insulating sleeve off of the battery, then use an
8mm socket to loosen the long bolt that secures the
battery tie-down strap. The battery can then be removed
and set aside.
