Versatrax 50™ In-Line
Document: UMBU014988.docm
Revision: A04
Created by: KJW
Date: 20 Nov 2019
IPN: 3080215-A04
Source Location: C:\ePDM\ISLEng\products\bu-vt50vehicles\manuals\UMBU014988.docm
Page 14 of 25
User Ma
nual
4. For unified integration, the Onyx camera head is supplied with an IE55 termination adapter which
allows it to plug into the interconnect cable on the front track. Ensure the adapter is fully screwed
onto the camera body. Attach the camera to the interconnect cable on the front track.
5. Power up the system so the operator can observe the video on the screen.
6. Place the Onyx camera into the skid with the face flush with the front of the skid. Rotate the
camera so the image is level. Install the top half of the two-part skid body using M3x12mm
socket cap screws. Avoid over-tightening these screws because they are anchored in plastic.
7. For 3½ - 4-inch pipe [90-102mm] add the spacer block IPN3089256 between the skid and skid
mount, as illustrated below. This will help reduce the up/down torque on the camera skid caused
by level mis-match between the skid and push link, which is always at the same level at the
bottom of the pipe.
