Versatrax 50™ In-Line
Document: UMBU014988.docm
Revision: A04
Created by: KJW
Date: 20 Nov 2019
IPN: 3080215-A04
Source Location: C:\ePDM\ISLEng\products\bu-vt50vehicles\manuals\UMBU014988.docm
Page 19 of 25
User Ma
nual
Power-Up Sequence
After all wiring connections have been made (as per ICON
™ Portable Controller User Manual), the system
may be powered up. The recommended sequence for power-up is as follows:
1.
Power on System (“SYSTEM” button)
2.
Power on Controller (“CONTROLLER” button).
3.
Power on embedded PC (“PC” button).
4. Start the ICON control (Inuktun controller) program.
ICON always begins with identification of attached system components (cameras, tracks, etc.). If vehicle
power is turned on after ICON is started, the system will not function until ICON is powered down and
restarted.
ICON™ & ICON™ RPT
Vehicle control and video recording are accomplished using ICON graphical interface controller software.
Video playback and reporting are conducted through ICON RPT.
Manuals for these two software
packages are included separately.
Controls for recording and snapshot functions are kept on-screen
with the camera controls.
•
ICON Manual
– (Control Interface and Recording)
•
ICON RPT Manual - (Reporting, Playback and Video Export)
Maintenance
Connector Care
Connectors are an essential part of system reliability. They must be properly maintained and cared for to
ensure long life and reliability. We recommend the following steps to help prevent damage and increase
the life of connectors.
•
Always use connector caps when available.
•
Always inspect the end of the connector prior to engaging to ensure it is clean and is the
correct match to the mating connector.
•
Never plug in a dirty connector
•
Visually align key-ways or locating pins prior to engaging the connector
•
Always fully engage or tighten the connector
•
Secure locking collars finger tight only. Tools can result in over-tightening which may
damage the connector.
•
Install dummy plugs on unused connectors
•
Disconnect by pulling straight, not on an angle
•
Do not pull on the cable to disengage the connector
