Page 12 of 40
The
*
Key - Program Checking
The
*
key is used to display current parameter data held in the EDAC 400-02. Select a function
and, whe
n the ‘
P
’
is displayed, press the
*
key. The data currently held in that function will
display (digit by digit in the case of multi-digit entries).
Exit to RUN Mode
Once all the functions have been programmed, exit programming mode by pressing
##
very
quickly at the
‘F’
prompt. The EDAC 400-02 should now display the
with a flashing dot. In
RUN mode the EDAC 400-02 is ready to accept an input trigger and make alarm notification
calls.
##
= Exit programming to RUN mode.
Restore Factory Defaults
Use this function to clear old or unknown parameters (user settings) and return to factory
settings. You can then reprogram each function from the default starting point
NOTE:
This procedure does not affect any existing voice messages.
WARNING:
The following instructions will clear your user settings from all
functions associated with an input, e.g.
#1
will clear the phone/pager
numbers, trigger type, wait time, message play time and call counter for input
one. If you wish to reset only one or two functions, look up those functions in
this manual and simply reprogram the data.
#0
=
Clear general parameters (functions
F01
to
F09
).
#1
=
Clear phone numbers and all parameters for Input 1.
#2
=
Clear phone numbers and all parameters for Input 2.
#3
=
Clear phone numbers and all parameters for Input 3.
#4
=
Clear phone numbers and all parameters for Input 4.
