Page 21 of 40
PROGRAMMING
– RECORDING VOICE MESSAGES
Function F0* Recording Voice Messages
The operator can re-record all voice messages in the EDAC 400-02. Voice messages are
recorded on to an analogue EEPROM for permanent storage using the microphone provided
inside the lid on the top left hand corner of the EDAC 400-02. The message is played back
through the onboard speaker. The Speaker Mute jumper (J600)
must
be in the top most position
(un-
muted) to hear any message playback. See ‘
PROGRAMMING - Jumper Setting
s’
for more
information.
Jumper J602 is provided to protect your recorded messages in EEPROM from being accidentally
erased. At the time of shipping the default position is to the down/bottom (unprotected) position,
allowing messages to be re-recorded, for your installation configuration.
NOTE:
You
must
ensure that the voice protection jumper (J602) is in the
down/bottom
position before attempting to record a message or your message will
not be recorded.
Play and Record control keys
All voice messages start with
0*
this is the function number. After this a ‘
P
’ for parameter will
be displayed and a parameter must be entered. Use the tables below to select a parameter for
the different voice message slots.
To
start recording
press
#
after entering the parameter number. Recording starts
immediately, and is indicated by an ‘
r
’ being displayed. Press any key to finish
recording. The message will be played back automatically. Then the ‘
F
’ prompt will
return.
To play back a previously recorded message enter
0*
followed by the parameter at
the ‘
P
’ prompt. Then press
*
to hear the message.
Press any key to return to the ‘
F
’
prompt.
F0*0
Site message (spoken to identify the EDAC 400-02 installation)
F0*9
Idle message (“All Inputs are clear”)
F0**
Cancel message (“The following Inputs have been acknowledged”)
F0*#
Output mode
F0*1
Input 1 alarm message (Eight seconds max)
F0*2
Input 2 alarm message (Eight seconds max)
F0*3
Input 3 alarm message (Eight seconds max)
F0*4
Input 4 alarm message (Eight seconds max)
F0*1
Output 4 On message (Four seconds max)
F0*2
Output 3 On message (Four seconds max)
F0*3
Output 2 On message (Four seconds max)
F0*4
Output 1 On message (Four seconds max)
F0*5
Output 4 Off message (Four seconds max)
F0*6
Output 3 Off message (Four seconds max)
F0*7
Output 2 Off message (Four seconds max)
F0*8
Output 1 Off message (Four seconds max)
Inputs
Outputs
