28
Pressing the conditioner/refiner’s RIGHT (
4
) button
manually advances to the next screen in the sequence.
Pressing the LEFT (
3
) button manually returns to the
previous status screen. If no buttons are pressed for
30 seconds, the automatic rolling sequence resumes.
ECOWATER
S Y S T E M S
Conditioner/Refiner Operation
FIG. 79
*
Water remaining before the next recharge.
During normal operation, the EcoWater Systems condi-
tioner/refiner’s display shows up to five status screens.
Page 34 explains how individual screens can be turned
on or off. Each is shown for six seconds, in a rolling
sequence (See Figure 81).
The “Wireless status” screen will only be shown on Wi-
Fi systems. The check marks indicate the following:
P
WiFi
- The softener is connected to a Wi-Fi router.
P
Internet
- The softener is connected to a Wi-Fi router
which is connected to the internet.
0.0 GPM
Water flow
2:34 PM
Salt status (NaCl)
2:34 PM
Water use (gallons)
2:34 PM
Out of salt in
119 days
Recharge status
2:34 PM
Set for automatic
recharge
Today: 121
Daily average: 175
Remaining: 736
Wireless status
2:34 PM
WiFi
Internet
-50 dBm
*
NORMAL OPERATION
CONDITIONER/REFINER STATUS SCREENS
Efficiency mode
Max. days between rech...
Auxiliary control
Special features
FIG. 82
Efficiency mode
Auxiliary control
Special features
Max. days between
recharges
FIG. 83
One second after being highlighted, the viewing box
expands (See Figure 83) to show the entire message.
After three seconds the view resets (Figure 82).
The conditioner/refiner status screens described in the
previous section will not be displayed in a rolling
sequence when one of the following items is displayed:
=
Recharge status
(Displayed during recharges,
showing valve position and time remaining)
=
Add salt
or
Out of salt
(See Page 42)
=
Current time
setting screen instead of status
screens indicates time has been lost, perhaps after
a long power loss. Set the time (See Page 32).
=
Service reminder
(See Page 40)
=
Error detected
(Contact your dealer for service)
FLASHING DISPLAY
The conditioner/refiner’s display will flash on and off
when one or more of the following conditions occurs:
=
Salt needs to be added
=
Time needs to be set (Time has been lost)
=
Service is overdue (Service reminder)
=
Error condition
The flashing will stop after any key is pressed.
However, it will start again at Midnight if the underlying
condition (e.g. low salt level) has not been addressed.
LONG DISPLAY SCREEN MESSAGES
Most messages in the conditioner/refiner’s display
screens are short enough to be shown as a single line.
Longer messages will be truncated (See Figure 82 for
an example) until you highlight them.
OTHER MESSAGES, ALERTS & REMINDERS
Содержание ECR3700R20
Страница 49: ...49 ECOWATER S Y S T E M S Notes ...
