19
X
X
X
X
X
4. Deleting room controls
To delete a room control, proceed as follows:
• Briefly press the ‘
x
’ button once.
• Select ‘Sonderfkt.’ (special function) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘H-Regler’ (H controller) using the scroller.
• Briefly press the ‘
x
’ button once.
• Select ‘Löschen’ (delete) using the scroller.
• Briefly press the ‘
x
’ button once.
By turning the scroller, you can now browse through a list of the available room controls.
• Use the scroller to select the component to be deleted.
• Briefly press the ‘MAKRO’ button once.
• The display briefly shows ‘gelöscht’ (deleted).
• Afterwards, you are back in the ‘Regler’ (controller) menu.
• If further room controls are to be deleted, repeat the steps previously described.
• If no further room controls are to be deleted, press the ‘
w
’ button three times briefly, one after the other.
Afterwards, the FHZ1000 is in the normal operating mode again
Ö
Please note:
If the control centre itself is not to control any valve operating mechanism, the ‘internal control’ should be
deleted, as described above. To do this, use the scroller to select the ‘H 0 Intern’ ( H 0 internal) control and
delete it.
The control centre now displays the current temperature measured in the room instead of the target
temperature.
If you wish to reverse the deletion (and/or register a valve operating mechanism directly with the control centre
again), the internal control (‘H 0 intern’) must be registered again as described above under ‘3. Registering
the room control’.
FHT 8W Heat Demand Relay
Installation and User Guide
Product Code EHC-FH06
1
