Eclipse PE300BU, Руководство оператора

Страница: 9 / 44

9
This machine is manufactured for
commercial use only.
This machine is designed and manufactured for
burnishing indoor hard floor surfaces. Amano Pioneer
Eclipse does not recommend use of this machine in any
environment other than an indoor environment.
Battery powered floor equipment is designed and
manufactured for commercial use only. These machines
are designed to burnish most modern types of floors
including composition tile, stone, marble, terrazzo, and
resilient floor covering, and some coated wood floors.
These machines should not be used
l
By unqualified or untrained personnel.
l
Unless properly maintained and adjusted.
l
On areas with obstructions such as thresholds, floor
outlet boxes, etc.
l
In areas where loose debris or other objects are
present.
Operator Responsibility
The operator is responsible for performing the
recommended daily maintenance and checkups of
the machine to keep it in good working condition. The
operator must inform the service mechanic or supervisor
when recommended maintenance procedures are
required as described in the “MAINTENANCE” section
of this manual.
l
Read this manual carefully before operating this
machine.
l
FOR SAFETY: DO NOT operate machine before
reading and understanding the operation manual.
l
Check the machine for shipping damage.
Keep your machine regularly maintained by following
the maintenance information in this manual. Order parts
and supplies only from an Authorized Amano Pioneer
Eclipse Distributor. Use the parts illustration section
of your manual when ordering parts. During and after
operation, perform the recommended daily and hourly
procedures outlined in the Maintenance Chart.
Test for Operator-Ear Sound Pressure Level
Amano Pioneer Eclipse measures and rates the
operator-ear sound pressure level for hand-guided floor
treatment and floor cleaning machines for industrial use.
All tests are performed in accordance with European
Machinery Directive (2006/42/EC).
l
Outdoor test area consists of a flat open space free
from effects of signboards, buildings or hillsides for at
least 15 m (50 ft) from the center of the test surface.
Indoor tests are conducted in a semi-anechoic or
sound deadening room.
l
The test surface is a single sheet of floor covering
at least 1 m (3.3 ft) wider and longer than the
equipment being tested. In order to not affect the
sound reading, the observer taking readings is at
least 2 m (6.6 ft.) from the equipment being tested, or
standing directly behind the operator.
l
All machines are tested while stationary and centered
on the test surface. With the traction drive in neutral
(where applicable) the test is conducted with the
machine at maximum engine or motor speed as
specified by the manufacturer.
l
The operator is located in the normal operating
position with the microphone or meter supported
independent of the machine, 1,68 m (66 in) above
the test surface, 25 cm (10 in) to the right and left
centerline of the operators position, and 20 cm (8 in)
to the rearmost point of the handle, with the handle in
the most forward position.
l
The sound level meter is observed for a minimum of
5 seconds or until a stabilized reading is obtained.
The maximum repeatable sound level observed
during the test at each microphone position is
recorded and documented.
Test for Hand-Arm Vibration at the Grip
Surface of Hand-Guided Machinery
Amano Pioneer Eclipse measures and rates the
vibration at the machine-hand contact surface of
hand-guided machines that are provided with handles
in accordance with European Machinery Directive
(2006/42/EC).
l
The test area consists of a flat open floor area that
allows the machine to be operated normally.
l
The transducer is mounted firmly at a point halfway
along the length of the handle where the handle
would normally be held.
l
Machines are tested while stationary, with all
mechanisms necessary for the equipment to perform
its intended functions engaged and the traction drive
in neutral (if applicable). The machine will be tested
at maximum engine or motor speed as specified by
the manufacturer of the subject machine.
l
The measurements are recorded from the dominant
axis.